I have noticed that both the Gladiator Pro and the T-Rudder MK. IV use the same sensor board.
I know that the MaRS Sensor (KMZ41) has an analog output, but the Sensor is connected to the "BlackBox" through an unmarked 2-row 8-pin Square IC Chip and a 550 ohm resistor. I have 2 questions, an answer (Other than its a "secret" or that it is impossible) to either would be extremely helpful for me to use the pedals in a project of mine.
What is the second, unmarked, square IC that is connected to the signal pin? (side-note: while it converts the analog signal from the MaRS sensor to a digital square wave, it doesn't appear to be an Analog-to-Digital Converter from the looks of its wave form on an oscilloscope or in practice)
What is the protocol that the unmarked chip converts the analog sensor data into?
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests