I'm getting a red blinking stick light when the TMW adapter is connected to the base. I found one other thread with a similar problem, but did not find a solution.
I'm using a Cougar stick. My understanding is the Warthog and Cougar sticks are 100% compatible. Is this correct?
Also I'm not sure how to verify the BB_GF-TM(1_85_2)0_79_99.cfg loaded correctly. Is the communications dependent on the config file?
I'm assuming it is not, because when I reinstall the KG12 I get a green stick light without changing back to the default config. Any help would be great.
Gunfighter Pro not working with TM Warthog Adapter
Moderator: AdminGroup
-
- Posts: 2
- Joined: Tue Jun 20, 2017 16:00
- Been thanked: 1 time
-
- Posts: 3277
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Gunfighter Pro not working with TM Warthog Adapter
You can compare the Led settings for different profiles and correct it to the correct one. Show screenshots of the Led bookmark, with two different grip.
- rrohde
- Posts: 618
- Joined: Thu Oct 08, 2015 9:28
- Location: USA
- Has thanked: 681 times
- Been thanked: 242 times
Re: Gunfighter Pro not working with TM Warthog Adapter
edswafford wrote:I'm getting a red blinking stick light when the TMW adapter is connected to the base. I found one other thread with a similar problem, but did not find a solution.
I'm using a Cougar stick. My understanding is the Warthog and Cougar sticks are 100% compatible. Is this correct?
Also I'm not sure how to verify the BB_GF-TM(1_85_2)0_79_99.cfg loaded correctly. Is the communications dependent on the config file?
I'm assuming it is not, because when I reinstall the KG12 I get a green stick light without changing back to the default config. Any help would be great.
Have a look here: viewtopic.php?f=27&t=2651 and here: viewtopic.php?f=27&t=2646 to get started. Please report back on how you're doing
Also, once the red LED issue is resolved, you then need the correct profile for all your TMW grip buttons to be recognized.
VKB North America
https://VKBcontrollers.com
https://VKBcontrollers.com
-
- Posts: 2
- Joined: Tue Jun 20, 2017 16:00
- Been thanked: 1 time
Re: Gunfighter Pro not working with TM Warthog Adapter
It looks like my problem was loading the cfg file. As I suspected the cfg did not load correctly. Clicking the Load button under the Action Tab is only half the job. In this case Load means read in the cfg file and possibly verify it is valid. The step I was missing was to program the controller which is done by pressing the Set button from the Action Tab. I figured this out after doing some digging and finding the "Gunfighter Basic Troubleshooting and Calibration Guide" topic in the Manuals and HowTo forum.
Who is online
Users browsing this forum: No registered users and 105 guests