VKB-SIM

Hi Guys,

I hope someone can help with this. I just received the T-Rudder MK.IV and flashed with the latest firmware, installed the Black Box and T link software. I was able to see that the pedals were connected and actually worked in DCS and BMS, two of my favorite sims, I was able to assign curves with no problem in the DCS flight controls options. Virtual brakes however do not show up as active in the VKB joytester. The Accu option is seemingly inop as well. I want to verify the virual brakes will work and assign curves to the rudder pedals......during calibration while moving the pedals nothing is happening on the T link AUX page. I am sure I did something wrong , but I do not know what it is. I tried a little using the configurator and the calibration function does nothing there either....its as if the Pedals aren't being recognized for those advanced functions.

I also got this: https://gyazo.com/eab9ee815fd4fd7763c98cbc997c81ff

it is an access violation HID.dll error.....

UGGGH!

Please help

1) Download and unzip:
- Profile for T-Link support http://ftp.vkb-sim.pro/Profiles/BlackBo ... 1_81_6.zip
- T-Link v.0.66.2 http://ftp.vkb-sim.pro/Programms/T_link_v0_66_2.zip
- VKBDevCgf-C v.0.78.9.9 http://ftp.vkb-sim.pro/Programms/VKBDev ... 78_9_9.zip
- VkbJoyTester http://ftp.vkb-sim.pro/Programms/VKB_JoyTester.zip

2) Run VkbDevCfg-C and load the profile to the controller:
- Click on the BlackBox controller name
- Click on the "Load" button
- Click on the "Set" button
- Close VkbDevCfg-C

3) Run T-Link
- Click on the "SET" square button (left side)
- Press a button on the joystick for "brake" function
- Click on the "Start/Stop" button (T-link start to send data to the BlackBox)

4) For test the brakes run vkbJoyTester (or can use Windows gaming controller applet). Choose the BlackBox controller. Press the "Brake" button on the joystick and move the pedals.

P.S. Never run T-Link and VkbDevCfg-C together!

Thank you soooo much! I set the brake source after start stop and never loaded the BB using config software .... I'm good now until I try and set a curve . Thank you!