VKB-SIM

After some time I have stick working pretty good, I have not been using WIZZO. I have been calibrating with the config file. when I try to use WIZZO the calibration light does not bling as stated in the tutorials. This leads me to believe I am missing something. Curious if anyone knows what might be the problem.
Thanks

Explain me in detail how you did the calibration. What do you mean - "calibrating with the config file" ?

VKBDevCfg-C
Choose, Highlight
Click calibrate

Doughboy wrote:After some time I have stick working pretty good, I have not been using WIZZO. I have been calibrating with the config file. when I try to use WIZZO the calibration light does not bling as stated in the tutorials. This leads me to believe I am missing something. Curious if anyone knows what might be the problem.
Thanks

If you can use VKBDevCfg.exe to configure joystick that is enough)) This tool is more powerful than WIZZO.
How did you try to calibrate using WIZZO? What messages have you seen and what was wrong? It is interesting for me because there are enough users who can not use VKBDevCfg.exe but also have troubles with WIZZO too. May be we can help them and make WIZZO better.

Wizzo looks and sounds like it works, but the calibration light does not blink.
I get error messages if I ever hit Bootloader

While in VKB DevCfg-C if I try to use the buttons tab I get following error message

access violation at address 00421CFF in module VKB DevCfg-C , write address 0000038A

Boot loader changes to settings to VKB Boot Njoy platform ......V00.56

Do not need to use Button Wizard, I just want to make sure stick is calibrating properly

Thanks

Doughboy wrote:VKBDevCfg-C
Choose, Highlight
Click calibrate

Move all joysticks axes with full range
Click "End Calibr"
Have you taken these two steps?

Doughboy wrote:Wizzo looks and sounds like it works, but the calibration light does not blink.
I get error messages if I ever hit Bootloader

Why you hit "Bootloader"? Bootloader is needed for firmware update.

While trying WIZZO I do move all axes fully. Not sure why the calibrate light does not flash.
Used Bootloader to see if I had newest version of software.
Will not use Bootloader ,it screws everything up.

What do you mean "Calibrate light"?
In WIZZO or Gladiator's leds?