VKB-SIM

Hello,

Problem using new version.If I try to set I get a message talking about index error :





What can I do to solve this ?

Best Regards

Need a Refresh firmware, try morethan early Configure.Take here.

Thank for helping. I have only this firmware : _Gladiator_VKB_v1_80_8__.vkb . Do I have to reload it (and how can I do this)?

Ok I have found this : _Gladiator_VKB_v1_81_9.vkb (I was mislead with the date of the post). I found how to upgrade firmware.
With 1_819 : ok I can set values in Galdiator pro. Thanks a lot.

Have fun

Try this version http://forum.vkb-sim.pro/download/file.php?id=4292
How to - look here https://yadi.sk/d/vJhGT6-Mqn2Z6 Brief_controller_En.pdf Firmware upgrade section.
Look here http://forum.vkb-sim.pro/viewtopic.php?f=15&t=2112 too. You can find a lot of interesting info))

False Joy, new version of devcfg has always same problem :





Fist tests were made with previous version of DevCfg.

Best Regards

It is necessary to go to Expert Mode and note these items.

Do not forget to add some lines to Zconfig.ini.

Problem still there.

As noted in all Settings, restart the configurator. With the new launch of our controller choose the left mouse button (click on the line with the name).

What I have done :
1. seting as indicated + lines in zconfig.cfg


2. restart DevCfg. Left Mouse select controleur (Gladiator Pro).
3. Load xxx.cfg
4 Actions > Set - Ihave the message "write data ok"
5. Error list index out of bound. Even when I use the default button I get the error.

What can I check now ? (No problems with previous version of DevCfg).

The check box should be marked.

No need to do to claim 3. You must click "Default" button and the controller will return to the factory settings.

Hello,

New day, new problems.

I have done exactly what is depicted in above post:
Start DevCfg
Settings as shown
Select controller
Default Action -> warning about data will be reset ->ok -> error : list index out of bound

I also had a crash of DevCfg (windows message application stop working). Some time,not always.

One thing I remarked is that I cannot set the "cal" tickbox on the first tab.

Other thing :I can use default in 0_78_85 without problem, but I cannot set the "cal" tick box in this version neither !







P.S. : Where can I find the different skin for DevCfg (and how to load them) ?
Have a nice day.

Mark "Cal" will itself after the first controller calibration in the configurator.

Try v. 0.78.93

Tried and no more error message. OK for the moment . Will do some more check to morrow.

Anyway a big thank for your help.

Have fun, be happy.

That's good news, thanks!