VKB-SIM

Hello everyone, from the first time I connected the stick on computer I noticed that the Y axis is not centered (just above), so i calibrate via wizzo.
These days I also had problems with thorttle Z axis, when is fixed at 75% circa the line is unstable on joy tester.



Even after calibrating it seems not work
Firmware: 1.80.8

Thank you

Hi Matt,

a few pointers here:

- Never calibrate VKB devices using Windows Joystick Applet; if you did, restore to the default setting from within Windows Joystick Applet!

- In WIZZO, calibration requires all axes to be moved to their full extent.

- With Gladiator (Pro), don't forget to calibrate throttle axis as well.

- Also, can you please provide screenshots from the VKBDevCfg software: we need the General page, and from the Profile page the "physical" and "logical" axes.

- In addition, what's your current Windows version?

Thanks.

thanks for the reply,

Windows version: W10 Home 64 bit






host image

Hi Matt,

I am sure someone more knowledgeable than me will give you an answer here!

Did you make calibration by windows?
Please send me screenshot from VKBjoytester. Don't move stick, but just move trottle wheel to full range few times by small speed.
I think, the throtlle potentiometer have problem. But I need to see the screenshot first.

Never calibrate with windows
I think you're right:

Thanks for your screenshot, I think problem comes from potentionmeter. Please contact your seller to solve this problem. If any questions, please feel free to contact me.

Ok thanks