VKB-SIM

So I received my stick today and was fooling around with Wizzo and I accidently messed my calibration up. I think I got it back calibrated right but I am not sure. When I press the stick fully forward it reads zero and when I pull it back it maxes out to some 356355 or something like that I can't remember, is this correct? This applies to my roll and yaw as well. Everything seems to be okay when I'm flying but I just wanted to double check. Also, I hit bootloader to see what that does but nothing happened except a CPUID error? Is that a big deal or would it effect my stick in anyway?

Your axes values are perfectly normal. Nothing wrong.
An axis range goes from 0 to 65535 and the neutral/center position is 32767 (unless it's a throttle/rotary).

I'm not home to test the Bootloader with WIZZO, but that CPUID error shouldn't interfere with your Gladiator if everything seems normal. Just in case, you can disconnect and plug the Gladiator back in.
I only used the VKB Device Config software to update the firmware.
If it works don't worry about the advanced functions (unless you really need to).

Thank you! I just checked my axis values and 32767 was showing for my roll and yaw axis and my pitch axis was showing 33020 but I'm assuming it's not a problem if it shows a slightly different value.

Not a problem at all: the different values result from the soft-free center of the Gladiator (no hard-center). That's a feature, not a bug

Bourrinopathe wrote:Not a problem at all: the different values result from the soft-free center of the Gladiator (no hard-center). That's a feature, not a bug

Oh okay thanks again sir for your quick response! Have a nice day