Cobra M5 axis not working
Moderator: AdminGroup
Cobra M5 axis not working
Hi,i have cobra with njoy32 controller i cant get Y axis working i tried connect both sensors and there is no movement,looks like something bad with controller happened..
Re: Cobra M5 axis not working
Raw value of Y axis is -1. The controller can not connect with Y-sensors.
1) Sensor does not work
2) Problem with cable or connector
3) Controller's port problem
Please, swap the sensors and upload dxtweak2 screenshot again.
1) Sensor does not work
2) Problem with cable or connector
3) Controller's port problem
Please, swap the sensors and upload dxtweak2 screenshot again.
Re: Cobra M5 axis not working
karel88l wrote:I tried no reaction from Y axis.
Long time ago I have had similar problem. Pay attention to cable connecting MARS with controller, especially 3-wire connector near sensor. It can look good, but wire is broken inside insulation plastic.
Руководство пользователя по контроллерам VKB (VKB controllers User Guide) Ru&En
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
Re: Cobra M5 axis not working
I tried both sensors and cables on X and Y axis they work only on X.But i realised when i hold cables connector not fully pushed into boards connector i can get movement on Y axis it looks like there is bad contact on controller,connector itself looks normal.
Who is online
Users browsing this forum: Bing [Bot] and 103 guests