VKB Device Config – Error CPUID read

[wavy]

Hello,
I recently bought a Gametrix ECS and have some problems setting it up.
I flashed firmware 1.35 and I'm trying to understand how to use the VKB Device Config v0.72.5.7 to adjust some settings. The first thing I noticed is that when I click the throttle on the top-left list it says Error CPUID read. So my first question: Will I be able to save any settings at all even if I'm getting this error? Why does this error occur?

This is why I want to use the software:
I'm using the throttle for flying helicopters in Arma 3. It's working, but I'd like to apply a slight curve around the center of the Axis so that the transition from collective up to collective down isn't as hard. Is it possible to achieve this with the software?

Unfortunately I don't speak russian – it was very difficult to find information about your software.

Many thanks in advance!

[Daisy]

Hi,

Will I be able to save any settings at all even if I'm getting this error? Why does this error occur?

yes, you can save settings if you use older version of VKB Device Config .
About curves, you can't change curves, because this Throttle was produced more than 2 years ago and it didn't use Njoy32 platform.

[wavy]

Hi Daisy!

So just out of curiosity, which version works with the ECS?
Too bad curves can't be changed, but thanks for your quick reply!