VKB-SIM

Here you have it.

A very confusing setting with overlap with other buttons - it won't work that way. Tell us what you wanted to achieve, what the algorithm of the buttons should be? Not forgetting that there is also a physical button 24 (microswitch) when the trigger is operating.

Try these settings.
We turn off the microswitch, we do not need it.

Configure Safe (4), Armed (3), Fire1 (1), Fire2 (2), Pulse, M0.

With such a dead zone (M0), Fire1 is triggered immediately, and when pressed further, Fire2 is added to it. With M1, when you turn on Fire2, Fire1 will automatically turn off. With M2, it will initially be the same as with M1, but when pressed fully, Fire1 will also turn on.

First of all thanks for the help.
What I whant is the most basic and clean configuration:a virtual button for each physical button. I thought I have it, thanks to you I have seen the error in the microswitch.
I have not been able to make the M1 and M2 options work, but I am interested in making it work the way it is working now: Armed presses virtual button 2, Fire1 presses 2 + 3, and Fire 2 presses 2 + 3 + 4 .
I am not interested in the Pulse function because I whant armed holding the virtual button.
Then the configuration is as in the image that I add to this comment .

Now it remains to know if this is what was causing the crash.....

Everything works as you wanted. Only without the first button (a hundred strange) - it is not in your algorithm. By the way, all dead zones work, you just need to correctly adjust the calibrated axis.

should I re-calibrate the metal trigger axis to make the dead zones works?

If there are no 255 and 0, then it is not necessary. You need to correctly set the sliders for the start of the fire1 and Fire2 zones.

Hello,
the same problem has come back again. The configuration of the metal trigger gets blocked and 3 of the 4 trigger buttons remain pressed simultaneously, for an indefinite period of time.
I attach an image of my configuration, although it can be refreshed by seeing the previous comments in this thread.
What can we still check?

Thanks

Reset to default and recalibrate. If you like to play with the profile I suggest save it immediately after resetting to default and calibrating, then save it again after making a change and testing it successfully. Go step by step and in the end you'll have a working profile.

Mmm, are you sure it's an efficient solution? I already reset the values before.
If I reset again, then I will need to configure the buttons exactly the same (especially the button number assignment) as I have them now so that the games I have will continue to work, ¿correctly?

Well, obviously you'll have to find another way to program your buttons, because this way it doesn't work, as you could see That's why I recommended to go step by step when saving a working copy of your profile, so you could revert to it instead of resetting to default if something goes wrong.

The way to calibrate the metal trigger is: all the way up, then down, then press all the way down, and release, is that correct?

Calibration process.

Ok, I'll try. Today, in the middle of a game, control of two 4-position buttons was lost and th devices appeared disconnected in the TEST/external device tab.
All other buttons and axes worked fine.

It's a bit desperate, I hope the reset works.

Reset to default and see if it happens again in game. If it doesn't, then it's your programming.