Stuck z-Axes Roll

[Floyd]

Ok. Physical axes

[Floyd]

Following your link:
1 - Device model and version
Gunfighter Mk.III - MCG Pro EN /w twist
VKBSIM-S-GF-MK3-MPR-EN1-TW

2 - Controller Firmware version
2.03.0

3 - Number and type of springs used
Original - Nothing changed
4 - Тype of cams used
Original - Nothing changed

5 - If VKB original software is used, please always mention its version
VKB device config: V0.91.78
VKB joytester: can not find any version number - not older than 3 weeks

6 - Vkbjoytester screenshots.

7 - Vkbdevcfg-c screenshots.
Already done

[Ron61]

Was this twist always or did it work fine? Update the firmware from here and attach your profile.

[Floyd]

The device is only 3 weeks old.
But i guess this issue only happened since a week.
I will update the FW and come back with result

[bravoleader]

Was this twist always or did it work fine? Update the firmware from here and attach your profile.

Mine usually works fine but it happens every now and then especially in the heat of a dogfight (of course) it gets stuck into "roll" (as I have mapped the roll to the twist of the stick) and I can't do anything aside from unplugging it quickly before I get blasted into pieces

HID-compliant game controller
Product Name: VKBsim Space Gunfighter
PRO version
T-Link supported
Firmware version: v2.050

[Ron61]

A custom profile is a profile file after settings and calibration, saved by the Load button in the configurator.
Please do not crop the screenshot of the configurator window.

[Floyd]

Ok. Updated to "_BlackBox_GF_MCG_PRO_Twist_v2_05_0.vkb"

That makes it even worse.
After default and calibration:
Axis Z is moving from 0 to 43316 (not 65535 anymore)
And is stuck 10 times more often then before.
Profile attached

VKB NJoy32 XT PRO profile 1.zip

(2.16 KiB) Downloaded 162 times

[Floyd]

I did now a single calibration for Z-Axis, that made it go from 0-65535 again.
More than 5 complete calibrations before did not work

[Floyd]

With new FW its not possible to play.
Z-axis stucks in both directions. Sometimes its possible to 'wake it up' by turning and turning, sometimes only restart helps.
And i don't think this is a HW problem.
If axis is stuck, i can start single axis calibration and move complete range.
After calibration is finished, axis stucks at 65535 again.

[Ron61]

Do you have an orange BlackBox? Choose the correct firmware - for the black plastic BB you need with the letters MK2 in the name.

[Floyd]

No, my black box is black...
And as you can see in my first screenshot, i never had an MK2 FW.
Not from the beginning.

[Ron61]

Add the lines to the zconfig.ini file as in the picture.

[bravoleader]

Same screenshots with no cropping

[Ron61]

And if you reset and calibrate all axes? Your ministik is not calibrated.

[bravoleader]

And if you reset and calibrate all axes? Your ministik is not calibrated.

I swapped that out for a 4 ways hat. I was not able to use it anywhere. at least now I can use those controls.