Software: 0.93.29
Issue: When two MCounter booleans share the same R input (same layer and button number), sending a R input will only reset the counter permanently for the M Counter with the smallest boolean ID. The other M Counters will reset to zero only as long as the R input is active. When the R input turns off, the counter reverts back to its previous value.
Reproduction video:
https://youtu.be/zvLTwHQCcEs
Reproduction steps on SCG Gladiator:
- Create M Counter with threshold = 8 in boolean slot 1, mode = No Overload.
- Set C input = physical button 10 (trigger).
- Set R input = physical 12 (red thumb button)
- Output 'Multi' to Physical button 105
- Create M Counter in boolean slot 2 with identical parameters as 1st but with output = Physical button 113
- Press physical button 10 seven times and observe on the Physical Layer buttons light up on in succession as the counter goes up:
- Physical buttons 112 and 120 are lit up after 7 trigger pulls.
- Hold physical button 12 to reset the counter:
- as expected physical buttons 105 and 113 light up and
- physical 112 and 120 turn off.
- Release physical button 12:
- physical button 113 (position zero for boolean 2) turns off
- physical button 120 (position 8 for boolean 2) turns back on
- Change layer for R input of boolean 2 to Virtual, same button number
- Reproduce steps 6 & 7, then release physical button 12:
- Physical button 113 correctly remains lit even after physical button 12 is released
PS: I realize Youtube could be hard to access in some countries, I don't mind uploading to other services if needed.
