VKB STECS 3 switch turned to axis is wronly calibrated

[UnnAmmEdd]

Hello.

I've made a change to turn my 3 switch into an axis in my STECS' front panel. I did everything same as in YT video on how to make an axis inside VKB config. My problem is that when I move switch to DN position, it has 0 value in VKB config, however when I move switch to the UP position, in about 60-70% way it get max (65535) value, and it stays the same when I push the switch forward to UP position. How can I calibrate the switch so it manage all the range of possible values during all it's way?

[fallout9]

Seems like a bug in the current version; we're looking into it.

[jukelo]

That switch uses automatic center calibration, so the position for the switch at the start of calibration will be taken as the center position. At the start of calibration you have to make sure it is in the middle position, then move it up and down for calibration to register both the center and the extreme values.

[Alex Oz]

check fw _STECS_v2_18_F_.vkb
need full reconfig (default->autoconfig->calibration)