[solved] Response Curve table values don't stick

[jukelo]

Firmware: 2.18.F(5), 2.12.2
Software: 0.93.19, 0.92.51

Issue:
When entering a value in a cell of the Response Curve table, the cell's new value is lost when clicking another cell and reverts to its previous value. The same happens when navigating with the Tab key to another cell.
Clicking the Response curve Diagram to open the Curve Wizard, or switching to a different tab (for example the Physical Axes tab) does properly save the value.

Steps:

1. Navigate to the Profile > Axes > Response Curve tab
2. Click the 10% cell for any row in the table on the left, change the cell's content to a different value.
3. Verify the response schematic on the right reflects the new value
4. Click any other cell:
   
   • Observe the value from the previous cell reverts to its previous value and so does the schematic
5. Repeat 1-3, then Click the curve diagram to open the Curve wizard before closing it again with either Ok or Cancel.
6. Verify the changed value in the 10% cell is still correct
7. Click any other cell:
   
   • Observe the value from the previous cell doesn't revert to its previous value

https://www.youtube.com/watch?v=WVkaph74sc0

[Alex Oz]

Check VKBDevCfg-C_v0.93.20