UCM Stronghold Mounting Adapter Plate for Gunfigther

[simmeone]

Hi,

I have an UCM Stronghold for the Gunfigther, but the adapter plate is a bit too short. Exists an extension or an longer adapter plate for the Gunfigther?


Regards

[Ron61]

Show me a photo of your plate so you can judge the size.

[simmeone]

Here two pictures.

[fallout9]

Can you elaborate on the 'too short' thing?

[simmeone]

I'm trying: my table has a small recess, see the picture. As a result, the table mount of the Gunfigther comes a little to the rear and is no longer on a level with the table mount of the throttle. As a result, my left hand is no longer comfortable on the throttle. The gunfighter would have to be moved a little to the back, 2-3 cm would be enough, but the plate would have to be a little longer for that.

[Ron61]

Longer ones do not exist and have not been produced. In your particular case, you can drill two additional holes to suit your preferred mounting angle. Approximately in this place, reassemble the bracket.