trigger problem new nxt evo

[ArtDev]

following your vid. : run cofig then select stick in window...I get this message

[fallout9]

Close the program and run again the procedure with VKBDevCfg in Admin mode.

[ArtDev]

I don't recall an option for "admin mode" but I will try to find one

[ArtDev]

OK. tried that and now it's flashing red and also flashing blue.

What did I do wrong?

and still telling me "need to calibrate"

that little box keeps popping up and stopping action. I can't get around it.

[ArtDev]

Red light still flashing overnight.

[ArtDev]

ok, did it again after computer restart.
closed the box at each step but when I push the "calibrate " button it doesn't go to the place where you check the axes. And it's just sitting there with blue light blinking for 1/2 hr so far.

What's up?

[fallout9]

It doesn’t automatically go to the test tab, you’ll have to be there yourself. Click the Test tab, then Axes tab, then click the Start Calibr button, calibrate and click End Calibr button.
Whole procedure here, at the end of the video: https://youtu.be/wPcmvcLkCx0

[ArtDev]

OK!

So I calibrated e of the axes.
What moves the others?

I have done this before and it didn't help. Do you think calibrating he flying axes will help the trigger problem somehow?

Rot x and Rot y don't move?

[ArtDev]

OK,

I did that and there is no change in the game. Guns cut out in hard maneuver chasing enemy

After I do all the calibration, I push "end" and the box still comes up and says "need to calibrate". Is that normal?

[ArtDev]

OK,
think I got something. Two stage trigger, light pull fires MG's, full pull fires cannons. If no cannons, nothing fires instead of "all guns fire" at second stage.

that vid was the one I was following but, it's a little tricky.. Finally got window to go away.



thanks