Can't boot GNX Dual THQ + THQ-V + SEM-V Combo

[Brickou]

Hi,

I have received a GNX Dual THQ + THQ-V + SEM-V Combo, but after trying to boot it up, nothing happened.

I have follow the instruction there https://www.youtube.com/watch?v=YX_DT4sUgag
but since my came already build (the 2 bottom GNX-THQ are linked already together and the same for top SEM-V and GNX-THQ) I have no idea what I am supposed to plug and where. ( It came with one double USB C, and another one to connect to the PC)
(For now I have tried with this cable configuration, see picture https://cdn.discordapp.com/attachments/ ... 165625.jpg)

Thanks if somebody could help for that.

[fallout9]

Connect the SEM with the THQ on the left with the USB C to USB C cable. Plug the USB C to USB A cable into the THQ on the right, then plug it to computer.

[Brickou]

Thanks your answer @fallout9

Didn't quite understand the instruction, but I managed to get it working by connecting the Top left SEM with bottom right THQ, with USB C to USB C, the bottom left THQ is plugging to the computer with USB C / USB A

But now I am stuck with configuration, the 3 led on the SEM are RED , bottom left THQ is blinking blue and red. https://media.discordapp.net/attachment ... height=896

And the software seems to regonize only 3 axis for now (the ones from the bottom right THQ,) https://media.discordapp.net/attachment ... height=897

Did I do something wrong ?

[fallout9]

The 3 LEDs on the SEM are fine, they're just programmed to be red in that position of the Flaps. You could reprogram them later if you don't like that.
If you managed to connect them properly then run VKBDevCfg and first press the Default button under the Tools tab, then the Find&AutoConfig button on the Global/External/ExternalDevices panel. Calibrate afterwards by pressing the StartCalibr button under the Tools tab, moving all the THQ axes up and down a few times, then pressing the EndCalibr button. At this point you're good to bind in game.