MCGU and Firmware 2.10.5

[InvaderZim]

Hi there,

Here is a short experience report for the new, unofficial firmware 2.10.5:

I don't know if it's something on my side, but my MCGU doesn't work with firmware 2.10.5.
After flashing, everything works fine, but after the PC has been switched off for a while, it no longer works. It is active and recognised, but it does not send buttons or axes.
Flashing the MCGU back to 2.09 everything is normal again.

Only the MCGU and T-Rudder (both Blackbox MK II) are affected, SEM, THQ and FSM-GA seem to work fine with 2.10.5.

Happy easter and best regards,
InvaderZim

[Ron61]

I confirm there is such a thing . Since these are test firmware, use the more stable, previous ones.