I currently have the MCG Pro mk II with twist axis and T-rudder pedals. Is there anyway to setup 9 axis?
Current Axis are:
- 2 on pitch/roll
- one on brake
- 4 on hats (2 on each of the MCG pro hats)
- 1 axis on the twist yaw
Is there anyway to use my pedals while all 8 physical axis are in use?
T-rudder Pedals with MCG Twist
Moderator: AdminGroup
-
- Posts: 40
- Joined: Wed Aug 12, 2020 16:14
- Has thanked: 4 times
- Been thanked: 12 times
Re: T-rudder Pedals with MCG Twist
If you are running current firmware, you can move an axis to a second virtual device, allowing you keep all of the axes.
Current firmware and VKBDevCfg - https://vkbcontrollers.com/?page_id=4609
The following is with MCGU, but the process is the same with MCGP. This will move the twist axis onto a second virtual device.
Open VKBDevCfg, change the settings outlined in red boxes, hit set, and recalibrate.
Current firmware and VKBDevCfg - https://vkbcontrollers.com/?page_id=4609
The following is with MCGU, but the process is the same with MCGP. This will move the twist axis onto a second virtual device.
Open VKBDevCfg, change the settings outlined in red boxes, hit set, and recalibrate.
Last edited by Tuesday John on Tue Apr 12, 2022 3:50, edited 2 times in total.
Re: T-rudder Pedals with MCG Twist
I was late))) Agreed. Tested on SCG Pro+twist. Connected 3-axes pedals. left HAT axes moved to 2nd VC and enabled toe brakes.
Руководство пользователя по контроллерам VKB (VKB controllers User Guide) Ru&En
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
Who is online
Users browsing this forum: Bing [Bot] and 46 guests