Wrong Firmware

[kwonjc7]

i accidentally install the wrong firmware on my scg dual sticks.

Set up:
left stick is gladiator nxt scg standard grip.
right stick is gladiator nxt scg premium grip.

when trying to update firmware was getting error message "device signature not correct - flash fail" please check version of firmware file for this device.

Tried using the "Gladiator_SCG_L_v2_2_09_0.vkb" firmware file... it did not work.... Out of an error i selected the "Gladiator_NXT_v_2_09_0_vkb" and it did update the flash.

Thinking that was the correct path, I flashed my premium stick with the same firmware.

Went into the config file and it detected a left and right stick.. but now both sticks are registering the same buttons and repeating itself... LED red light stays on... i get random LED blips on the base led lights... did i just make my both of my sticks bricks? how can i correct?

[fallout9]

That is the correct firmware for any Gladiator NXT, be it Premium or Standard, Left or Right.

After flashing press the Default button under Tools tab, then navigate to Global/External/External Devices and click the Find&AutoConfig button.
At last, go to Test/Axes1 and press Start Calibr button; move the joystick along pitch, roll, twist it, move the minithrottle up and down, press on the center push button on the A1 ministick (the Premium grip only) so the LED turns red, then move the ministick all ways around. Press End Calibr and you're done.