I need some expert's advice for the setup of my Gladiator NXT's encoder wheel as virtual axis for zooming in DCS.
Here's my system info:
1 - Device model and version: Gladiator NXT R with SEM
2 - Controller Firmware version: v2.088
5 - VKB Device Config v0.92.17
And that's my configuration:
- I set up one of my NXT's encoders as virtual axis.
- This virtual axis is linked the zoom axis in DCS World.
This basically works out, BUT:
- As I need a quite large multipler (x512) the zooming is not smooth but rather jumpy.
Question: is there any way to soften the curve of the axis?