GF III Dry clutch issue and cam roller not engaging fully

Moderator: AdminGroup

Kaalrabistu
Posts: 10
Joined: Tue Jul 13, 2021 6:04
Been thanked: 1 time

GF III Dry clutch issue and cam roller not engaging fully

Postby Kaalrabistu » Wed Aug 11, 2021 16:57

Hi,

I started messing around with clutches today, I have not used this feature before and wanted to check it out. It appears the tightening screw is snagging on the clutch brakes, probably because the holes do not align properly. It seems the brakes holes push the screw to one end, and the upper hole of the frame have been threaded because of it (see picture). This causes the screw to just tighten the upper clutch brake and does not engage the spring at all. Can I drill this out myself without voiding warranty? Just to check if this will fix the issue? Was thinking of drilling out the hole in the frame as it has already been partly threaded.

https://1drv.ms/u/s!AggxpKbBrw3IwmXzp632ZsdT4HhI?e=ahOtjU

Also the cam roller on roll axis does not engage cam fully. I noticed this piece here sticking out a bit. I presume this is press-fitted, should this be flush with the frame? That distance would make the roller engage fully.

https://1drv.ms/u/s!AggxpKbBrw3IwmYXKl1iepKIkZyX?e=DBawtL

User avatar
fallout9
Posts: 5461
Joined: Wed Oct 03, 2018 20:37
Has thanked: 222 times
Been thanked: 1268 times

Re: GF III Dry clutch issue and cam roller not engaging fully

Postby fallout9 » Wed Aug 11, 2021 18:20

Please fill up a service ticket with your vendor.

Kaalrabistu
Posts: 10
Joined: Tue Jul 13, 2021 6:04
Been thanked: 1 time

Re: GF III Dry clutch issue and cam roller not engaging fully

Postby Kaalrabistu » Thu Aug 12, 2021 8:29

Done


Return to “Technical Support”

Who is online

Users browsing this forum: No registered users and 10 guests