Tempo, POV and Microstick Switch

[nneeee]

On my MCG Pro, I have the Gate Cont Hat by default controlling POV 2.

For the mapping, I have it on microswitch switched by Tempo B.

This means that when I click the Hat, it will press button 8. If I hold the Hat for longer than Tempo Time, It will switch the Hat to Axis Slider 1 and Rot Z.

Is it possible to add an additional button press to the microswitch?

For e.g

By default
Hat controls POV 2
Click Hat presses button 8

Microswitch
Press and holding Hat press and releases another button 30 (based on Tempo)
Switches Axis to Slider 1 and Rot Z
Press and holding Hat again press and releases button 30 and switches back to default control

[fallout9]

Try this:

Set up Gate Cont ministick like this:

Set physical button 22 as uSSw for POV2 switched by TempoB. Link it to physical button 30:

Make Tempo1 of button 30:

Make Boolean as JMP to link Physical button 22 to Physical button 30:

Press the Set button after all this to save it to profile. Make sure you're calibrated before doing this. Also buttons 30 and 31 might interfere with high and low limit for the brake lever (inactive by default) if you ever want to set them up; if you do then either change the buttons in the configuration above or the ones activated by the brake lever.

[nneeee]

That worked perfectly fallout9, thank you.