Changing LVLNG button to black color

[david_wi]

Hi Guys

Just wanted to change the LVLNG button to the black button on my MCG Pro.
This button has two little knobs on it, so it seems it can’t be changed without completely opening the grip.
Help please
Thanks, David

[AeroGator]

Yes David out of all buttons this one requires opening the shell.
On the bright side, when you open it you will be able to enjoy the interior that we are particularly proud of.
And by the way check the two screws that hold the grip on its shaft. Even if the grip doesn't wobble, it's good to check them on convenient occasion.

[david_wi]

Thanks so much AeroGator

[marcusstratus]

I was just about to ask about this myself. I'm not able to tell how to access this button after I've opened the grip. Are there more screws that need to take out before the front panel comes off... or is it just slid into place? I'm also paranoid about pulling wires or damaging green chips, so a brief explanation would go far.

[david_wi]

I was just about to ask about this myself. I'm not able to tell how to access this button after I've opened the grip. Are there more screws that need to take out before the front panel comes off... or is it just slid into place? I'm also paranoid about pulling wires or damaging green chips, so a brief explanation would go far.

You are absolutely right for fearing wire damage and such.
I kept the gray color button as it is too risky to move inside the grip with no drawings to help.

Bye, David

[Santagio]

Just like you guys, I took it apart the switch out the grey. When I saw it was hiding behind circuit boards I noped it back together.
A detailed tear-down or even blow up schematic would be most welcome.