VKB-SIM

Once there is a tool, you can find out what stresses are between the points in the picture:
1-2 =
1-3 =
1-4 =
1-5 =

Show better the Profile-Axes tab. Let's try a couple more settings - in Profile-Buttons, remove the uSSw stick switch (change it to Button). At the same time, in Profile-POVs, change 8way to Discrete, Set, calibrate all axes. Screenshot. I made a video just in case. If all else fails, then you can r...

When calibrating from the configurator, you don't need to press any button on the GNX. After moving all axes, you need to end the calibration by pressing End Calibr.

Before disassembling the grip, change the MPL multiplier from 8 to 9, write it to the controller (press Set) and try to calibrate with these parameters, show the screenshot.
Leds on the base will blink until all axes are calibrated.

That is great.

The question is, where are both GNXs connected to? Interested in the version of the USB port. Let's try to flash with the latest firmware from here the configurator for it is here 92.05), reset it to default. Leave only the right GNX connected, open the Profile-Axes tab, calibrate the axes of the mi...

Very strange. Button 30 can only be pressed when changing the ministick to a push-button hut. Show the photo of the ministick by first deflecting it in any direction.

Show the tabs Global-External Devices, Profile-Buttons, Test-External Devices.

Show tabs Global-External Devices, Test-External Devices. What LEDs are on BB when the base is connected? BB orange most likely?

The reason for this behavior of the axis is extremely simple - the magnet of this particular axis has come unstuck. Corrected in 5min. with a few drops of glue. Unfortunately, this happens, sorry. During assembly, this particular assembly will be more thoroughly checked.

Until the values of the 5th and 6th axes change from 255,255,0 to others in the specified area after calibration, there can be no talk of any adequate operation of the microstick. Try to activate the Partial Calibration checkbox in Setting and select only the 5th and 6th axes of the microstick durin...

It looks like a problem with the connection to the USB port. And the first thing to check is the USB cable itself. If there is a tester, then you need to ring it for the presence of contact of all conductors.

That's right, this led shows the presence of voltage on the base controller when connected to the BB. The problem is not clear - the handles are not detected during installation, or what?

Show the Profile-Axes after calibration and Profile-POVs tabs.

If you have the equipment and skills in soldering, then while the new cable is delivered, you can fix the problem yourself. In the photo, red is connected to GND. The correct position of the cables can be easily checked when the configurator is running - if it is wrong, there will be a short circuit...