VKB-SIM

You could try temporarily disconnecting all Razer devices. They can be the reason for this behavior.

These screenshots indicate a temporary loss of communication between MCG and the base. Since the twist is in the handle, this can affect it. Do the same monitoring with the base itself. You can display 2 windows at once.

Try changing the MPL parameter value from 9 to 10 on both axes, write it to the controller with the Set button and recalibrate. Show screenshot.

And if you reset and calibrate all axes? Your ministik is not calibrated.

Your X and Y axes are not calibrated - this is indicated by the numbers 255, 255 in the physical axes. When calibrating, I advise you to be in the Profile-Axes tab (and not in the Test) and move the axes more vigorously, lingering at the edges for half a second. Then, after calibrating and rebooting...

По первому скриншоту можно сделать вывод, что нет физической связи датчика педалей с ВВ (на 7й оси при нажатии зеленого треугольника горит красный квадрат). Пока не будет зеленого квадратика - калибровка бесполезна. Попробовать вставить плотнее (аккуратно) вилку в педали. Сбросить настройки в Defaul...

All impatient questions - what do you think will be the answer to such questions about future products, if they are asked, for example, Thrustmasters or Logitech?

Show again the Profile-Axes tab after calibration, only from it you can understand the essence of the problem.

Generators can be used, see chapter 4.3.16 on page 72 of the manual. Choose the one that suits your needs.

Add the lines to the zconfig.ini file as in the picture.

Do you have an orange BlackBox? Choose the correct firmware - for the black plastic BB you need with the letters MK2 in the name.

A custom profile is a profile file after settings and calibration, saved by the Load button in the configurator.
Please do not crop the screenshot of the configurator window.

Was this twist always or did it work fine? Update the firmware from here and attach your profile.

Instead of Curves, you need Phyzical Axes.
And take the trouble to clarify your configuration according to this post.

Show the Profile-Axes tab.