VKB-SIM

I tried the calibration again, now it is just noise on the X Axis? I would say something is dirty, but it is hall sensors right?

Thanks, but this has not improved anything. I clicked the default icon before recalibrating. The brake is not twitching nor is the master mode, but the master mode is not functional down or right. In the AXIs is still moves slower to the right than to the left, and the same with down. There is still...

Here you go.

Also I noticed the Master mode slides to the left faster than it slides to the right, and faster down than it moves up. Personally I think something has broken.

Hi Fallout, thanks for your reply. I have followed the instructions you provided exactly, after downloading all the items suggested in the video from the link you sent. Sadly it has not improved anything. My POV1 still jumps, my brake still jumps, and my X AXIS is rough at the extremities. I use POV...

Hi, I keep getting Phantom inputs. I have uploaded a video of the effects I get in the VKB tool. First 30 seconds show how stuttery my roll input is, also random fluctuations on the brake lever, I did not even touch the brake lever. Last 15 seconds of the video you can see the red POV switch fluctua...

My issue seems to be resolved. I did not realise there was new firmware. I updated to this and all seems fine now.

Hi,

As title says, I am getting phantom inputs on my stick. I thought it might have been a the gimbal, but I am getting them on the brake axis on my MCG.

DO I need a new orange box?

Any suggestions for where to start to solve this issue?

Regards

Andy

Ok, I have followed your instructions. Everything seems ok. If I am not complaining in the next 10 minutes, it means I am enjoying blowing stuff up

Great thank you. I must go out now. I will view this later, and hopefully I will be able to blow up some targets

As long as it can detect this in DCS as single key presses for 4 directions up, down, left, right and centre, on both mini sticks, I do not care how it is achieved.

I want to use this stick primarily for DCS.

I want the Master mode to be buttons not axis. I will use this for targeting slew.
I want the Gate Cont to be buttons, not axis. I will use this for trimmer.

Everything else is as I want it.

I am happy to reset and start over.

still does not work.

BTW I have no knowledge of how your configuration software works, everything I have done is from reading what other have tried. Lack of clear step by step guides on how to achieve desired profiles really leaves me confused on how to create the profile I want.