VKB-SIM

Okay, It turns out the red light is totally normal. Spike issue on the roll axis still remains. Seems like there are no other ways but for waiting for respond of VKB HQ. The reason I didn't open a ticket is that I bought directly from the VKB HQ, not from North America website. I posted my problems ...

Gunfighter Rev.B Pro with MCG Pro. I bought it a month ago.

After peeling all Red,Black,Yellow lines a bit and connected them back and glued them, I have Red light from the base and my roll axis spikes like crazy.








Seems like I touched some self-destruct button. Gotta pack up and get out of here.

And the Yellow one has just disconnected...


..............

Another update. disconnected.jpg It seems like a whole connector is a defect. Another wire (the black line) has fallen off from the same connector. That happened in the tournament fight today 10 minutes ago, during an excessive roll maneuver. Gimbal of the gunfighter is really sturdy and well-made t...

Show the photo of the controller board more clearly, the connector itself. As I understand, the pins remained on the board, and the plastic outer shell itself remained on the "mother"? If this is so, then you need to disconnect this pair and put it neatly on the pins. On your photos you c...

If you're ok with DIY, you could get a connector online at digikey.com. As long as the board solder points/pad/plated solder holes are good, you can fix it yourself with a little solder work. They (VKB) seem to use a lot of standard connectors like the SWR201-NRTN-S04-RL-WH with 2mm pitched pins. F...

Hello. Today, I was flying with Gunfighter as usual and all of a sudden my plane started tilting one side. I started joytester immediately and I found that my roll axis not responding. so I unscrewed the base plate and opened the base and one of the wire has disconnected by a repeated roll (I guess....

If the vkb mcg tm is directly compatible with warthog base without firmware updates, Will mcg tm also be compatible with vpc base as well?

Both Gunfighter and Gunfighter pro have same gimbals in it?

If so, when I extend by using an extension tube, will it has too wide range of motion to handle?

or there are some ways to reduce the total range of motion?

I have a question about Gladiator pro.

as I know the maximum angle of the gimbals is +- 20 degrees per each axis.

When the gladiator pro with the extension tube, is it possible to adjust the angle of the gimbals?