VKB-SIM

It turns out that there can be such options. It's good that it ended this way. Bingo!

Не могли бы показать фото контроллера внутри? Можно попробовать подключить через хаб, желательно USB 2.0. В современных материнках такие могут быть только на меcте подключения клавиатуры и мыши (где раньше PS/2 были). Либо приобрести такую планку с портами USB и подключить косичкой к материнке. Ну и...

Look here, I think everything will become clear.

Посмотрите личку.

Mouse axis control moved to Profile-POVs-Output in the latest firmware versions. Look over there.

I get it now. Thank you.

You have button 29 assigned to actuation from the brake lever, at the very end of the axle (A2B tab, MCG Brake checkbox). I advise you to update the firmware to at least 2.05.3, as indicated in the very first line of the configurator at the top. You can take it from here , flash it, and observe. Wit...

Одних слов мало для понимания проблемы. Показывайте скриншоты вкладок из конфигуратора Profile-Axes, и работу осей в JoyTester в центре и при перемещении от края до края.

Just in case, let me remind you that when you install the handle and do not fix it rigidly with breadcrumbs, false triggering of buttons and axes is possible. It is advisable to enable monitoring of the connection between the handle and the base and check the quality of this very connection at the m...

Your photo is not very informative, it is impossible to see anything on it. Please make it in a higher resolution, you can save it on a third-party resource and throw a link here. You also need screenshots of the Profile-Axes configurator tabs (logical and physical after calibration) and a screensho...

You have not provided any screenshots from the configurator and photos from the inside.
Only one word, this is not enough. We need facts for technical support to understand the essence of the problem.

The fact is that, perhaps, your problem is solved within 30 seconds, right on the spot, without leaving your home. In this case, you do not need to send anything anywhere. Therefore, I highly recommend taking a photo, it is not expensive in terms of time and money. I hope for your mutual understandi...

Please take a photo without the bottom plate like this one. This is necessary to clarify the location of the problem.

I advise you to update the firmware and configurator from here. After that, calibrate all axes on the handle (not forgetting about the axis of the weapon switch). Showing screenshots of the Profile-Axes tab after calibration.

Заходите в скайп, там всё и объясню. Можете проштудировать руководство по этому вопросу.