VKB-SIM

I made changes as you suggested, but still not as I need for my configuration. I now get two presses again, and also the Gate Cont still does not register a press. Also button 24 stays lit now.

Thanks Ron, I will make further changes.

I have set up using the following settings below. I no longer see AXIS for these mini sticks which is good. The problem I have now is when I press Master mode up I get button 14 and 30 together, all other directions and centre button are as I want them. The Gate Cont still only registers the centre ...

Yes, I set up using that, but when I press the centre button on Master mode, I end up with centre and two other two buttons. Gate Cont does not register a press at all in the test screen. I also see the axis moving.

Happy to accept I am doing this all wrong.

I don't know how to do this. When I try setting master mode as buttons, it usually mashes several buttons together, so i guess I need to set deadlines or something. A guide would be really useful.

I have latest version of devconfig now v0.87.05, still see axis and POV move together, but no need to answer my post, I will just sit back watch, and see how this resolves. It will effect me when TDC axis is fixed on AV8B. For now I will try and set up master mode switch as buttons.

Sorry to jack you thread, but I am having exactly the same issue. I am trying to use master mode for TDC in DCS AV8B, and the slew function of the TDC is uncontrollable. Also same issue trying to use gate for trim.

GF PRo Reva MCG Pro
firmware 1.94b
VKB Dev config 0.83.96 (latest I can find)

It is the USB cable to the black box. It works now, I just got to figure out how to set all the buttons up in DCS.

Hmmm... seems a crap USB cable is causing the issue. Wiggling it make the box respond.

Did this issue ever get resolved? If so how?

Same with no joystick connected to Black Box. I see this in device manager

Gunfighter pro RevA. MCG Pro RevA
Firmware Version: 1.94.B

Now Windows shows me a message saying the device has malfuctioned. Windows is no longer detecting my Gnufighter

Sorted it. I found this article.... https://vkbcontrollers.com/?p=8185

I have green lights and am good to go and blow stuff up now

DO I have to flash the firmware so it can see the MCG? If so, Z-Bootloader does not see my device. I read that I maybe have to short Boot jumpers on my device. I have taken it apart to look for such a jumper, but I do not see one. Is it on the Black box?

Black box still flashing after attaching MCG to my Gunfighter Pro Rev A. I have run the VKB device config also. Black box shows as if I did not have a grip attached.

What am I doing that is incorrect?