VKB-SIM

Did the X axis cable inside the base be reconnected?

Reconnect the X-axis cable, on both sides, and calibrate again. After, show a screenshot from the Profile-Axes tab.

English is not my native language, google translator translated it like that :) . It meant the presence of single-axis pedals connected to the 7th axis. Or a twist connected to the same seventh axis. Gladiator with twist 7th axis 7.png MCG with a twist on GF. Ext.png Axes.png Or the GF variant with ...

For virtual brakes, you need 7-axis pedals or a twist instead of pedals. Only then will it be possible to realize them.

Сheck your mail.

Repeat all the actions as shown in the video by clicking on the button that interests us. What result?

It is necessary to disassemble the handle and make sure that nothing extra fell into the twist during assembly.
Perhaps the screws are tightened very tightly. This was the case, it was worth disassembling and assembling and it all worked.

If the trigger axis in the MCG Pro handle is not calibrated, then any buttons associated with it will not work correctly.
Look in the Profile-Axes-Axes2Buttons tab for the numbers in the KDHi, KDLo and Bias columns - they should not be 255, 255 and 0.

Все крайнее находится тут. В папке "Архивы" найдете последнюю версию 1.82. Учтите, что после не бесплатного апгрейда Cobra Z в King Cobra, вам станут доступны все крайние прошивки с новыми возможностями. Выбор за вами.

The answer is here.
The principle of firmware is described in the manual.

И этим действием отрезать и ручку тормоза и одну ось с левого стика? Это не наш метод... .
На всякий случай, посмотрите эту тему. Чем черт не шутит.

Even without a mechanical lever, we can emulate its work. The twist axis does not have to be absolute. It will make both a throttle and a zoom (the Cn check box is removed), etc. As a result of the settings, from one axis of the twist we will have two independent ones. Switch between them hang on th...

After resetting to default, the button to the configurator is calibrated and we get approximately such numbers.

The manual says this for 3-pin D-Mars sensors. When it was written, other sensors simply did not exist. They were only in development. Therefore, it is worth focusing on the MPL digits, which are set after a reset to default.

А может вы их готовить не умеете :)? Если вы считаете написанные пару постов здесь помощью, то это мизер. Т.с. общая информация, которая необходима для понятия уровня погружения в тему настроек. Вы не смогли найти возможность реализации предложенных мной трех вариантов связи - как минимум, это стран...