VKB-SIM

Проверку работы каналов датчика по совету Alex_Oz делали, результаты есть?

You have a little confusion in understanding the macro number and timing, but this can be easily corrected by looking at the picture. Let me explain that you can only run the second macro of 4 buttons, you just need to assign a button to it. As well as only the 5th of the two. Try lowering it from 5...

You can use an old plastic 3-pin connector. Make a 3 pin out of a 4 pin one. The white one can be attached to the spring.

That is great.

Change 11 to 7, write it to the controller with the Set button and it should work.
If it doesn’t work, reset it to default on the new firmware (2.17E) and try to calibrate again.

Select the pedals and take a screenshot. And show the Profile-Axes tab.
Try updating the firmware and configurator from here.

With pedals connected to BlackBox GF, reset them to default using the button in the configurator and show a screenshot of the Global-External tab.

What version of BlackBox is used with GF MCGU? Show me the photo.

Сильно сомневаюсь, что найдется такая, но поищем.

Reset to factory state using the "Default" button in the configurator and re-do Auto-configuration with the corresponding button (appears next to the "Find&Show" button).

Так это зависит от установки перемычки и в дефолтном состоянии это норма. Смотрите видео.

Click the Find&Show button and show a screenshot of the window. You can try updating the configurator and firmware from here.

Show how you connected and a screenshot of the Global-External tab from the configurator.

The minimum recommended firmware version for this configurator is indicated in brackets. Higher is possible, lower is not. The numbers 255,255 indicate that the pedal axle is not calibrated. And without this, adequate operation of the axis should not be expected. I advise you to update the firmware ...

Show the Profile-Axes tab from the configurator.