VKB-SIM

I don't see any problem with HAT A3.

Everything seems to be correct, but I ask you to make a video from the Test tab with the Log checkbox activated. And test starting from the top position and continue clockwise. Finally, press the center HAT button.

Well, all the buttons for you work at the physical level. The layout on the logical layer got lost (or so configured) - show the screenshot of the Profile-Buttons- Logical layer. It can be fixed in two clicks, but we need to analyze it in more detail.

How to master it all? Maybe you need to write something more concisely?

How to show? Well, this is how, for example, the physical buttons of the hut A3 should work. Therefore, I ask you to check it out.
First, we need to figure it out at the physical level, and then we will understand it at the logical level.

So how many buttons are not responding? I only see one 8th worked. Where are the others?How many red squares light up when you move the HAT completely in the Profile-Buttons?
Show the configurator window in full, without clipping.

Раз твиста нет на 3й оси, отключаем в Global-External Devices её - ставим вместо М-MarsX,Y None. Педалей, как я понимаю, тоже нет - отключаем несуществующие оси 6,7,8 в Profile-Axes сняв галки En, Vs. Делаем джампер на кнопку Shift, как на картинке. JMP.jpg На 36й делаем переключатель на 3тью ось по...

Activate the Poll checkbox in the Profile-Buttons tab and check all the buttons on this HAT. Red squares should light up in all HAT positions.
If this does not happen, then open a support ticket from the joystick seller.

Возможно всё, только нужно больше данных. Какая ручка используется - с твистом или без? Скриншот из Profile-Axes покажите.

Причин может быть несколько, поэтому почитайте личку.

It's easy to do, I'll show you step by step. 1. in the zconfig.ini file, at the bottom of the [User] section, add lines for each profile, like Profile 1 (... 255) = DCS Spitfire and close the file with saving № profile.jpg 2.after that, in the configurator, in the Global-Common tab in the Profile ID...

In the information line of the configurator, its version (92.06) and the recommended firmware version (in brackets) are indicated. You can use a version higher than the recommended version, but not desirable below. If everything works for you, then don't worry.

That's great, just great!

Change the conductors in the connector according to the picture.
It should be - green, white, red, black. Only on the connector on the controller side, do not change on the sensor.

The sensor cable may have been loose or damaged during magnet handling. Please check it out.