VKB-SIM

That's right, that unit will have to stay on the desk.

Show us a pic with your setup, OP, so we can see if you can integrate the 2 modules into the UCM; for example, if you have 2 UCMs you can get a module on each, so you won't need the MFH anymore.

Please post a screenshot of Profile/Axes/Logical and Physical Axes chart.

This is a completely unrelated issue, most probably an uncalibrated device.

So, if you want to run the SEM and FSM as an independent unit you'll need the following: - SEM, FSM-GA, MFH (you already got these); - JST to USB C cable ; - GNX HID Controller . You'll install the GNX HID Controller into the SEM, connect the SEM to the FSM by the JST to USB C cable (JST to SEM, USB...

Contacting the vendor by email or from the contact page on their website is the way.

If the throttle is properly calibrated and the axis still acts like that please fill up a service ticket.

Please update to the latest software and firmware, then reset to default and click Yes for the config button. If still not working afterwards fill up a service ticket with your local vendor.

I think we already responded to this on the tickets; if not, please fill up a ticket with the issue.

Maybe the cable is bad, do you have another cable to try?
Also try swapping USB ports too.

Can you post a pic with your setup please?

Just close and run again VKBDevCfg, that should fix it.

Thanks for the update.

Any electronic device might get damaged if it's under permanent vibrations; now it depends how hard it's vibrating and other factors, but probably you'll be fine. I suggest though to put a sheet of rubber between the throttle and mount plate, to act like a buffer.
Nice setup btw

Fully release the dampeners and make sure the gimbal is moving freely https://youtu.be/HRC5uPpFPzk

Please download the attached file, then extract it in the same folder with zBootloader. Run zBootloader as Admin, make sure the BBIII is in bootloading mode (disconnect other devices to make sure), then erase everything from the command line and type in: load . Try to flash the Unified firmware afte...