VKB-SIM

If the throttle is properly calibrated and the axis still acts like that please fill up a service ticket.

Please update to the latest software and firmware, then reset to default and click Yes for the config button. If still not working afterwards fill up a service ticket with your local vendor.

I think we already responded to this on the tickets; if not, please fill up a ticket with the issue.

Maybe the cable is bad, do you have another cable to try?
Also try swapping USB ports too.

Can you post a pic with your setup please?

Just close and run again VKBDevCfg, that should fix it.

Thanks for the update.

Any electronic device might get damaged if it's under permanent vibrations; now it depends how hard it's vibrating and other factors, but probably you'll be fine. I suggest though to put a sheet of rubber between the throttle and mount plate, to act like a buffer.
Nice setup btw

Fully release the dampeners and make sure the gimbal is moving freely https://youtu.be/HRC5uPpFPzk

Please download the attached file, then extract it in the same folder with zBootloader. Run zBootloader as Admin, make sure the BBIII is in bootloading mode (disconnect other devices to make sure), then erase everything from the command line and type in: load . Try to flash the Unified firmware afte...

The ETA for the MCGU is mid to end of May. Please mention in the order notes that you need it with RevB connector.

With the BB in the same stage as in your screenshot above (bootloading mode, with blue light and OK for Boot Device) clear the command line (where the firmware name is) and type: save . Check the folder where zbootloader is stored, zip the .op1 file you'll find in there and attach it to a message he...

If you've been charged once for VAT surely you won't get charged a second time, just keep the invoice handy for delivery as proof.

Trying to include the GFII too, but can't confirm at this time, sorry.

Visit our Discord server about it, more focus on SC over there.