Search found 7 matches

by Degorth
Mon Jan 29, 2018 3:13
Forum: Technical Support
Topic: How to use MCG-Pro POV 2?
Replies: 9
Views: 7370

Re: How to use MCG-Pro POV 2?

For anyone looking for how to do this, here's how. You must set POV2 to LoRes 8w, then set the X axis to 6 and the Y axis to 5, and set Active to Always. Additionally, depending on your preference, you can set Active to On/Off so that the POV can be enabled/disabled by a button set as a uStick Switc...
by Degorth
Fri Jan 12, 2018 8:25
Forum: Technical Support
Topic: Changing Master Mode axis mode to absolute breaks swap functionality
Replies: 10
Views: 6433

Re: Changing Master Mode axis mode to absolute breaks swap functionality

Thanks for the firmware and software update, though the problem still persists. Here's what I'm doing. From default profile, Master Mode switch acts as POV and uses relative axis when axis mode is activated. I go to the section pictured earlier and set those two values from Rel (relative) to Abs (ab...
by Degorth
Thu Jan 11, 2018 15:56
Forum: Technical Support
Topic: Changing Master Mode axis mode to absolute breaks swap functionality
Replies: 10
Views: 6433

Re: Changing Master Mode axis mode to absolute breaks swap functionality

Sorry, maybe I didn't explain it well enough. With axis set to relative: Master Mode does EITHER axis OR POV, but not both. Holding the push button swaps between the two. With axis set to absolute: Master Mode does BOTH axis AND POV. Holding the push button disables POV but keeps axis. What I'm tryi...
by Degorth
Wed Jan 10, 2018 16:11
Forum: Technical Support
Topic: Changing Master Mode axis mode to absolute breaks swap functionality
Replies: 10
Views: 6433

Re: Changing Master Mode axis mode to absolute breaks swap functionality

I tried that as well, but it only enables/disables the POV. It acts as an axis in either case, meaning it will do both POV and axis or just axis. I can't seem to make it only do axis OR POV when set to absolute.
by Degorth
Wed Jan 10, 2018 12:57
Forum: Technical Support
Topic: Changing Master Mode axis mode to absolute breaks swap functionality
Replies: 10
Views: 6433

Re: Changing Master Mode axis mode to absolute breaks swap functionality

Right, that's understandable. Here's the picture.
fRipqrq.png
by Degorth
Tue Jan 09, 2018 5:34
Forum: Technical Support
Topic: Changing Master Mode axis mode to absolute breaks swap functionality
Replies: 10
Views: 6433

Changing Master Mode axis mode to absolute breaks swap functionality

When attempting to set the MASTER MODE/РЕЖИМ КБО ministick's axis mode from relative to absolute, it stops being able to swap from POV to axis via the push button and instead does both at the same time. Is this intended? Here is a picture of the settings I am attempting to adjust: https://i.imgur.co...
by Degorth
Mon Jan 08, 2018 22:41
Forum: Technical Support
Topic: How to use MCG-Pro POV 2?
Replies: 9
Views: 7370

How to use MCG-Pro POV 2?

Hello! Just recently got my MCG-Pro and I'm trying to figure out how to activate POV 2. I assume this is controlled by the GATE CONT/УПРДВ СТРОБ ministick, but I can't seem to get it to work in VKBDevCfg-C (v0.83.85). I'm running the Gunfighter Mk.I (Firmware v1.917), so I can't use the Wizzo softwa...

Go to advanced search