Search found 7 matches
- Mon Jan 29, 2018 3:13
- Forum: Technical Support
- Topic: How to use MCG-Pro POV 2?
- Replies: 9
- Views: 7465
Re: How to use MCG-Pro POV 2?
For anyone looking for how to do this, here's how. You must set POV2 to LoRes 8w, then set the X axis to 6 and the Y axis to 5, and set Active to Always. Additionally, depending on your preference, you can set Active to On/Off so that the POV can be enabled/disabled by a button set as a uStick Switc...
- Fri Jan 12, 2018 8:25
- Forum: Technical Support
- Topic: Changing Master Mode axis mode to absolute breaks swap functionality
- Replies: 10
- Views: 6596
Re: Changing Master Mode axis mode to absolute breaks swap functionality
Thanks for the firmware and software update, though the problem still persists. Here's what I'm doing. From default profile, Master Mode switch acts as POV and uses relative axis when axis mode is activated. I go to the section pictured earlier and set those two values from Rel (relative) to Abs (ab...
- Thu Jan 11, 2018 15:56
- Forum: Technical Support
- Topic: Changing Master Mode axis mode to absolute breaks swap functionality
- Replies: 10
- Views: 6596
Re: Changing Master Mode axis mode to absolute breaks swap functionality
Sorry, maybe I didn't explain it well enough. With axis set to relative: Master Mode does EITHER axis OR POV, but not both. Holding the push button swaps between the two. With axis set to absolute: Master Mode does BOTH axis AND POV. Holding the push button disables POV but keeps axis. What I'm tryi...
- Wed Jan 10, 2018 16:11
- Forum: Technical Support
- Topic: Changing Master Mode axis mode to absolute breaks swap functionality
- Replies: 10
- Views: 6596
Re: Changing Master Mode axis mode to absolute breaks swap functionality
I tried that as well, but it only enables/disables the POV. It acts as an axis in either case, meaning it will do both POV and axis or just axis. I can't seem to make it only do axis OR POV when set to absolute.
- Wed Jan 10, 2018 12:57
- Forum: Technical Support
- Topic: Changing Master Mode axis mode to absolute breaks swap functionality
- Replies: 10
- Views: 6596
Re: Changing Master Mode axis mode to absolute breaks swap functionality
Right, that's understandable. Here's the picture.
- Tue Jan 09, 2018 5:34
- Forum: Technical Support
- Topic: Changing Master Mode axis mode to absolute breaks swap functionality
- Replies: 10
- Views: 6596
Changing Master Mode axis mode to absolute breaks swap functionality
When attempting to set the MASTER MODE/РЕЖИМ КБО ministick's axis mode from relative to absolute, it stops being able to swap from POV to axis via the push button and instead does both at the same time. Is this intended? Here is a picture of the settings I am attempting to adjust: https://i.imgur.co...
- Mon Jan 08, 2018 22:41
- Forum: Technical Support
- Topic: How to use MCG-Pro POV 2?
- Replies: 9
- Views: 7465
How to use MCG-Pro POV 2?
Hello! Just recently got my MCG-Pro and I'm trying to figure out how to activate POV 2. I assume this is controlled by the GATE CONT/УПРДВ СТРОБ ministick, but I can't seem to get it to work in VKBDevCfg-C (v0.83.85). I'm running the Gunfighter Mk.I (Firmware v1.917), so I can't use the Wizzo softwa...