Search found 6 matches
- Sun May 20, 2018 8:23
- Forum: Official announcements
- Topic: Unveiling the VKB TECS Throttle Control System (In Development)
- Replies: 335
- Views: 2856600
Re: Unveiling the VKB TECS Throttle Control System
Thanks for the update AeroGator!
- Thu May 17, 2018 16:50
- Forum: Official announcements
- Topic: Unveiling the VKB TECS Throttle Control System (In Development)
- Replies: 335
- Views: 2856600
Re: Unveiling the VKB TECS Throttle Control System
Any updates on the progress of the throttle?
Ive been using the tiny MS FFB2 paddle throttle in my left hand since I picked up the Gunfighter Pro with MCG Pro, holding out for the VKB throttle to replace it.
Ive been using the tiny MS FFB2 paddle throttle in my left hand since I picked up the Gunfighter Pro with MCG Pro, holding out for the VKB throttle to replace it.
- Thu May 10, 2018 19:11
- Forum: Technical Support
- Topic: Springs were snapped off
- Replies: 10
- Views: 7440
Re: Springs were snapped off
Just had a 50 spring snap in the exact same way as the pics above.
I'm only running single springs at the moment.
I'm only running single springs at the moment.
- Sat May 05, 2018 17:28
- Forum: Technical Support
- Topic: MCG loose base
- Replies: 45
- Views: 39504
Re: MCG loose base
Found my stick had a similar issue (first batch). One of the screws was not tight at all, the other also needed a bit of tightening.
Pulled it all apart as per instructions and have used spring washers as well.
Feels much better now, no movement any more in the base of the stick.
Pulled it all apart as per instructions and have used spring washers as well.
Feels much better now, no movement any more in the base of the stick.
- Sat May 05, 2018 17:25
- Forum: Technical Support
- Topic: Gunfighter Cam Smoothness
- Replies: 3
- Views: 3670
Re: Gunfighter Cam Smoothness
I found I had one of the cams (the one with a centre detent) that felt bumpy when the stick was moved in that direction only. As I was tearing the stick down for another issue, I pulled out the cam in question and spent 10 minutes with wet and dry 1200 grit sandpaper on the offending surface. This h...
- Sun Jan 07, 2018 20:22
- Forum: Technical Support
- Topic: VKB Gunfighter Pro Mk2 - Safe spring levels
- Replies: 3
- Views: 3524
VKB Gunfighter Pro Mk2 - Safe spring levels
Is there any recommended limit to the use of the springs in the base?
Is it possible to use 2x 50 springs on each axis without causing damage if someone wanted it that heavy?
Is it possible to use 2x 50 springs on each axis without causing damage if someone wanted it that heavy?