will hijack the thread a bit.
Since gunfighter mk1 and mk2 had a different set of cams (which are smoother than new avia-s cams) is there a way to buy those these days? anyone knows?
Search found 5 matches
- Thu Sep 03, 2020 19:01
- Forum: General discussions
- Topic: Cams & Springs
- Replies: 10
- Views: 7095
- Fri Apr 24, 2020 19:27
- Forum: Тех. поддержка
- Topic: Gunfighter лопнувший подшипник
- Replies: 1
- Views: 2139
Gunfighter лопнувший подшипник
Здравствуйте Сегодня обновил GF mk.II до внутренностей GF mk.III и установил кулачки Avia-S с новыми двойными пружинами на 50. Во время тестирования раздался хруст, и ось Y начала заедать в одном направлении. После разборки и осмотра оказалось что треснул подшипник на кулачке оси Y. До апгрейда стоя...
- Thu Nov 01, 2018 13:15
- Forum: General discussions
- Topic: Soft cam centering missing on MK4 rudder pedals?
- Replies: 2
- Views: 2233
Re: Soft cam centering missing on MK4 rudder pedals?
AFAIK its the same cam, you just flip it and use the opposite side. Though that was a bit too uncentered for my taste, even with high tension.
- Sat Sep 29, 2018 21:25
- Forum: Technical Support
- Topic: MCG Pro Trigger A2B misfuntion after setting X/Y axis response curve
- Replies: 21
- Views: 10942
Re: MCG Pro Trigger A2B misfuntion after setting X/Y axis response curve
... Also experiencing that the roll axis center randomly ends up being off by 5% or so, repeating the calibration identically until expected result achieved.... Here is another potentially useful story then (though for off-centers it can be all sorts of other issues). If you are experiencing "...
- Wed Sep 26, 2018 14:04
- Forum: Technical Support
- Topic: MCG Pro Trigger A2B misfuntion after setting X/Y axis response curve
- Replies: 21
- Views: 10942
Re: MCG Pro Trigger A2B misfuntion after setting X/Y axis response curve
Something I've noticed a few days ago, which might relate to this. The whole MCG Pro trigger becomes "unstable" with safe/armed being mixed up or fire1/2 buttons non-functioning after you re-run calibration. I did it a few times (using all axis or just x/y) until it just started working. I...