VKB-SIM

In DCS P-47 controls you need assign the virtal axes created for T-Rudder for "Wheel brake left"and "Wheel brake right". I have not tested with P-47, but for me T-Link brakes work OK for P-51, Bf 109 and Fw 190 "toe brakes". So I take this to mean assign joy_z to wheel...

I tried to figure out this Brake thing and thought maybe I should update firmware. Well I have all the latest config, bootstrapped, etc.....but Rudders are now not even activated .....ugggh this needs a step by step instruction please.

I did all the steps shown in the earlier post of how to setup virtual Brakes. Joytester shows it behaving as it should, similar to russian planes and the spitfire with the accumulator. In DCS P47, I am not getting differential braking as expected. I hit set....than depressed my brake assignment, tha...

I have managed for quite some time using the direct programming to tame the incredible accuracy of the T rudder. I am using a new program which unfortuneately does not have direct programming to desensitize the rudder. I would like to better understand how to use the software to achieve the desired ...

In the T link software, the latest I think....there is an advanced feature. If you select it, it opens a new panel with a whole bunch of features, and values for each of them. Saturation, Calibration, and Deadzone. Could someone please point me in the direction of discovery! Where is some guidance f...

Can someone please explain how to access the curve manipulation interface for the T rudder? I want to adjust the sensitivity of the rudders so I won't be all over the runway on takeoff in DCS Spit! I have set the Rudder Curve to 32 with a saturation of 90 in the Y in the DCS UI. I find it helpful to...

I have set my Virtual Brakes with T Link software, I want to set curves for the Rudders to reduce sensitivity. Is that the ACCU function? if so how do I set a curve? Helo!

Thank you soooo much! I set the brake source after start stop and never loaded the BB using config software .... I'm good now until I try and set a curve . Thank you!

Hi Guys, I hope someone can help with this. I just received the T-Rudder MK.IV and flashed with the latest firmware, installed the Black Box and T link software. I was able to see that the pedals were connected and actually worked in DCS and BMS, two of my favorite sims, I was able to assign curves ...