VKB-SIM

Thank you Delta for showing the way in VKBDevCfg, this is an amazing piece of software.
I changed the LED's so that what is for me the landing switch now controls the LED's. Switch down, LED's green. Switch in the middle & up position. LED's red.

Thanks Delta, will certainly have a look into this. Hopefully I get the LED's working also in DCS & IL-2 as those are the sims I fly.
(Shameless question: maybe a mod also for these sims?

Ok, thanks for the reply.
Maybe you can make a controller in the future where the electronics for these switches are swapped. So that both switches stay in place but that the top one controls the flaps and the large one controls the landing gear.

Hello, Is it possible to swap the landing gear switch and the flap switch together with the landing gear lights? To me what is now the switch with the label "Flaps" looks more as a landing gear switch. So I would like to swap the switches but then also that the lights "Landing gear&qu...

Hello, I'm using a STECS Standard combined with the GNX MFH & GNX SEM-V module. It is a very nice setup and works great. The only question I have: could there be a version of the GNX MFH with shorter feet so that the SEM-V module comes closer to the throttle? Even with full throttle forward ther...

Thank you very much for the solution and the expalanation.
This gives two STECS modules within the flightsims. Lots of buttons now available without the need for additional software.

Hello, As we all know, IL-2 still has this 62 button limitation. With my previous throttle I could use Joystick Gremlin to overcome this. But now, with the STECS I run into a problem. I've added the STEM module and the GNX SEM-V module to the throttle. When I use the UP-Down (Flaps?) switch on the S...

Problem solved. What I had not realized at first is that the software somehow blocked the newly attached module.
Setting it back to "Default" and then do a calibration again has the complete STECS now working.

I have one GNX SEM module mounted on the FMH module at the front. And one STEM module at the back of the throttle.

Hello, When I bought the STECS MAX I also mounted the GNX SEM on the FMH module. Today I have replaced the ATEM module of the STECS MAX with a STEM module. In the config software the STECS and the GNX SEM are visible in the External Devices in the config software and all buttons on the STECS and the...

Oh please, make the KG12 all metal now..., give the old planes also the 'real feel'

Hello Ron, No, nobody else under my name. After receiving the new stick I wanted to flash to the latest version. Because of the message at the end of the flash in the bootloader I wanted to know if the message 'read error: 0' indicated an error or not. I could not remember this from previous times. ...

Hi,

Can you please advice on the VKBDefCfg-C version you use?
In the version I have VKBDevCfg-C_v0_91_1_2 with _BlackBox_GF_MCG_PRO_v1_98_E.vkb I do not see the screen you are showing.
This how my screen looks:

Thanks Ron for your explanation. The bar showing the bus connection with less = better is a bit counter intuitive as I thought that more bars lit would mean stronger signal. I also don't need to worry then about the almost non-visible green light in the black-box. I used to see this as bright as the...

Hello, I have a question about the signal strength that is shown in VKBDevCfg-C external devices. Today I tried to configure the new stick and noticed a strange behaviour of the bootloader. It would flash the blackbox but in the end, where it should reset it finished with a "read error : 0"...