VKB-SIM

Thank you that's fantastic, I ordered the plugs from your link, very much appreciated.

I had searched Ali Express before but thinking the pitch was 1mm could not find anything suitable

John

Thanks Ron

Your reply is very much appreciated I'll have a look and see what I can find

If I do find a suitable replacement I'll post up a link to it

John

Attached is the page from the instructions

Board is item #4
Plug that's broken off is X2 as labelled on the board



As an alternate if that board is available as a replacement I'd gladly purchase it instead

When disassembling my Mamba with MCG grip to replace a swtich that had broken one of the connectors on the adapter board broke off It's a 4 pin angled connector I think they are called JST connectors. However they come in a bewildering number of types and I was looking for some help to establish the...

As nobody's responding I guess you guys are all out of ideas I'm begining to think the problem lies somewhere in the Firmare or a minor hardware fault that I've had since day one It's never been serious enough to stop the stick working in any way, but is interfering with the software. Possibly somet...

So spaced out the board as requested by Ron, before doing this though the VKBDevConfig-C went blank again I don't know if this is relevant but going to the Settings showed this up Setting Profile Fail.jpg I don't know what the dx Input manager is or where it's located though. I noticed that trying t...

You got it Ron I'll do that, thanks for the observation

John

Sure Ron I'll do anything you ask me to I'm unsure though what you mean by "Can you take a look at the photo of the stock pad?" Here is the Profile-Axes tab Profile Axes Tab.jpg Short video of the axes configuration page operating the grip and Mamba base dials, hats, stick etc: here https:...

So I have no idea how long this will last or if it's permanent I had to take the stick to pieces to take the photoographs in the previous post (obviously). I just reopened VKBConfig-C again now and the device registered. Here is what I am getting VKB Device Config Working.jpg I recalibrated the stic...

Thanks Ron although I'm unsure what the results told me. All I saw was a green line progressing along the bottom, I'll post up pictures and any observations on that later. First a base line so as I know what I've done so far is correct and there are no major blunders on my part Here is the wiring of...

So without warning suddenly the Config program started to show the axes, then went blank again. I also noticed that the stick was dead at one point and after a while realized this was related to one of the dials on the stick base. When rotated to almost the stop the stick died FM_mk1_Comment.jpg So ...

I think I am getting somewhere, with your help Ron61 but still experiencing problems When I initially loaded the firmware the went to the VKB Config program it showed the X, Y axes and the brake as a slider. However I moved the program to where I want it to load from, it was initially in downloads a...

I just did a hardware reset and this time the Bootloader completed the operation

However loading VKBDevConfig-C_v0_90_3_5 still gives me the Old Firmware warning and it would appear that the New Firmware is not getting loaded into the stick

So loaded up the new Bootloader and tried it, when I ran it, I got the result below, you can see it ends with an Error Write data, I have no idea what that message is trying to tell me Z-Bootloader Error Message II.jpg When I run the VKB Device Config, first I get an error that I'm using old firmwar...

I'll try that Ron thanks so much for replying and assisting

I'l report back either way

John