VKB-SIM

Show the Profile-Axes tab settings.

Make a few changes, press Set and show the curves from Joytester when pressed gently (a couple of times) and then dropped (a couple of times).

In JoyTester, this is how it should be when you smoothly click on itself and at the end when dropped. Show your curves.

No need, the magnet is clean, which is what I needed to check. Do an axis check on this video. What happened?

Will not damage, you can check with a light bulb.

MCG Pro has a full 4 way HAT on the left, under the thumb. MCG has just one button there.

Temporarily, flash the BB with firmware from, for example, pedals. Then the correct one.

You may need to disassemble the grip and see if there are any metal particles on the trigger axis magnet itself.

Good. There are several more options for renovation.
Try uninstalling the VKB device in the USBDeview utility, then reconnecting it to USB, wait for the system to install and try to calibrate it again.
Doesn't help - try the latest firmware from here.

You can disassemble the grip on the disconnected GNX and remove (the twist cable does not need to be disconnected) carefully the board, check the operation of the button with a tester. The photo shows two contacts of the button, which are closed when you press it. Our task is to find the source of t...

Did you prepare the trigger before calibration? Then, when calibrating, you do not need to hold the trigger when dropping. It is necessary from the Armed position (before that, he was already pressed as much as possible to himself), simply throw it away with the outer side of the finger, without hol...

С PS4 работал, но конфигурировать нужно было на PC.

Answer a simple question - when you activate the Poll checkbox in the Profile-Buttons-Physical layers tab and press C1, what happens? Does the red square light up?

Reset the settings to default and recalibrate. It would be nice to record it on video and post it here.

I see that the calibration is not entirely correct. Therefore, firstly, in Settings, check the Partial Calibration checkbox - this will allow you to select the axes that need to be calibrated. Secondly, try this method of trigger calibration - we will prepare it before it - smoothly press from the m...

For cable management.