VKB-SIM

Resolved! You found one of the reason behind this. The other factor one was the USB cable I used to troubleshoot. Yes, apparently I accidentally changed the subaddress from one of the units during a reset, and I couldn't resolve it with the software. The first bug happened here. But when I took the ...

1) Put GNX USB controller to THQ-V (subadress 2). As a single unit, worked fine. Defaulted and autoconfigured. Buttons and axes responded normally https://www.dropbox.com/scl/fi/jhdhwuoqopou8sr1tadjy/THQVsub2.png?rlkey=hea2inqcmsrox1icsgs680gdp&st=dsxby96w&dl=0 . -connected it to adjacent SE...

Switched GNX USB controller to SEM-V module. Autoconfigured. Again as a single unit it works fine https://www.dropbox.com/scl/fi/v2eboplebmzpobni24tee/Screenshot-2025-07-20-172422.png?rlkey=ftngghl85317vklijm449nee1&st=2muvxihv&dl=0 I connected adjacent THQ-V with 4-pin JST. Again malfunctio...

Pics of connections as attachments
Edit. HTTP error, put them in dropbox here https://www.dropbox.com/scl/fo/nvz472mnsmolljacwzgxe/AO8zaq_WQiin8FPVQcMba5g?rlkey=2ldimh85penjxqsrkolf7rlwc&st=gtemb9o8&dl=0

Connected modules THQ sub 4 to THQ sub 3 with a 4-pin JST With regular firmware the device malfunctions. I tried both JST slots on the right side on the sub 3 THQ, nothing changed. I also tried to connect via USB-C bus link (JST 4 -pin to USB-C cable), the same issue. Also when sub 4 THQ was connect...

I downloaded newest (to date) firmare (v2_19_D(3)), VKBDevConfig (VKBDevCfg-C_v0.93.36) and zBootloader2 (v1_97) With only THQ sub 4 (with GNX usb controller) connected, I flashed it with the firmware _GNX_USB_Controller_v2_19_D.vkb. The controller is recognized correctly. Then I connected the other...

Should I use zBootloader v.1_97 with the newest date, or v.2_01 with the highest version number?

I tried so set new subadresses to THQ units via pins: THQ (sub 4, with WWII grip) -(JST 4-pin)> THQ (sub 3) -(USB)> SEM-V -(JST 4-pin) -> THQ-V (sub 2) I avoided using subadress 1 on THQ modules, since i believe this whole mess began with the THQ-V module with this subaddress: when the jumpers are i...

I also tired to swap all 4 pin JST wires connecting the GNX modules and USB BUS wires. It didn't resolve the issue.

I'm using VKB device config v0.93.43 (NJoy32 firmware v2.19.B), the program is running with administration priviledges. On windows 11, newest version. I've got GNX module combo consisting 4 controllers: THQ(sub 4)->THQ(sub 3) -(USB-C bus cable)> SEM-V -> THQ-V (sub 1), I believe there has'nt been an...

Any ETA when the separate grips for Gunfighter Mk.IV are available in Europe?