VKB-SIM

Time to finalize this conversation :) Ok, I suppose the support has run out of gas, or had said everything there is to say. Thanks anyway, guys. As I mentioned, it's easier for me to do electronics part than mess with mechanical fittings, so replacing MARS sensor with new VKB sensor with a serial in...

Don't we all love progress, Ron? :) I am a bit less electronically challenged than mechanically, everything else being equal.. Is there a picture of the sensors (or drawing) I could see how they could be fitted into the existing fixtures? Alternatively, what kind of bus (I2C..?) if I hook up some ar...

Ok Ron, thanks for clarification, since you're the expert on the subject, could you clarify that RJ45 pinout is as follows: 1 : GND 2: 3.3V OUT 3: GND 4: 5V OUT 5: ? (analog input terminal 1) 6: 3.3V OUT 7: ? (analog input terminal 2) 8: 3.3V OUT Can pin 4 be used as a VCC for KMZ/UZZ pair? Provided...

Ok, Now I did my homework, turns out, this rudder MARS sensor requires 5V (it's KMZ41/UZZ9000 pair). Pedal brakes are most likely just simple pots, no problem there with 3.3V that BBox uses. Does RJ45 connector support 3 inputs? 2 for brakes, and 1 for rudder axis? I need to figure out how to feed 5...

Thanks, Victorus, I received BB Mk3 today, figures, I need BB Mk3 RJ45 connector pinout information, where can I find it? Original controller board, the rudder MARS has pads on the PCB, also each brake pot has pads, all that can be wired to RJ45 patch cable for BB. I will probably de-solder original...

top view

Hi Victorus,

Here are some pics if that helps, it's one of the original models from when VKB just started building them, under name Mk I or Mk II ...:

Hey gents, I am a lucky owner of a pretty old model pedals ( circa 2012..), that were on the shelf for a bit of time, so happens, I need them again. The issue is under Win10, plugging in USB adds entry under Human Interface Devices - USB Input Device, with exclamation triangle on it - Properties sho...