VKB-SIM

Totally understand that, Fallout. We all make mistakes. I don't fault VKB for that. How we treat people on the receiving end of our mistakes is more the point. How senior members of a community, employees or otherwise who are more knowledgeable than others, treat those seeking assistance, is also th...

Done. Thanks, Fallout.

When I first went to the website and looked under support, it recommended coming to the forums. Is it best practice to just immediately file a support ticket instead?

How much can you write about the correspondence between the configurator version and the firmware? Once again - in the configurator header (topmost line), in brackets, the recommended (minimum) firmware is indicated. Higher is possible, lower is not. Follow this simple rule. You always have a choic...

CONFIRMED! This fixed the issue on my Gladiator NXT EVO as well. Thank you, Delta. Thank you, Native for taking the time to remark on here that a fix actually worked for you too. That is quite helpful for others. However, this only adds to my point in another thread. Simple measures on the part of V...

I'll have to try this. Same thing happened to mine after the firmware update. Lost a throttle axis on my THQ as well.

Here it is

I don't see it either, @Delta. There is a black rectangular brick with 4 pin holes in that position instead.

See attached photos of master and slave THQ

Master


Slave


Slave Jumpers

@fallout Thanks. I can upload those later today. Absolutely. My PC PSU? More than fine. Run plenty of stuff with no issue, including VR. Dead Walking and I worked on this last night with little headway, but here's an update. Apologies I didn't post sooner, it was late and I was another 5 hours into ...

In trying to resolve this, I put it back on vkbdevcfg and hit default with the board out of the device. It changed the name to - 'VKBSim NXT XT2 v2.165'. No axes show up. Put the combo back together and no luck. I do have it back to showing up on the machine, but now I can't get the combo recognized...

I submitted this privately through the website, and was then directed to post my comments here so they would reach the proper channels. Below is a copy of my email. Thank you for your consideration. -- "Dear VKB, I have some suggestions/observations to send your way, but first I would like to s...

BRICKED AGAIN No change to anything on my PC today. Device just stopped showing up when I started up my PC and I can't get it to come back by switching to different USB ports now. Have rebooted multiple times with it plugged and unplugged. No difference. Light flickers for split second when pluggin...

Thanks, Fallout. Perhaps you are right, but I suspect the cable was still bad based on some issues I was having that went away with a new one. However, the story isn't over...unfortunately. So I'm mostly back in operation as you can see from the previous message. However, the one thing lingering is,...

FIXED!!! Have to say though, you all (VKB) have some serious problems on hand with these devices and your processes/user-'UN'-friendliness. I will send more suggestions through appropriate channels, but this whole thing consumed about 20 to 25 hours of my week and all kicked off with trying to follo...

Making progress... 1. Used a laptop (Windows 11) and FLASHed the firmware 2_16_5 USB Controller with no issue. Nice and smooth. LED immediately went into flashing mode. Verified with VKBDevCfg and it no longer showed up as Njoy32. 2. Placed the board back into the THQ and used VKBDevCfg to set to de...