VKB-SIM

Thanks Alex, 2.20.6(2) fixes it.

Firmware: 2.20.6 Software: 0.93.72 Issue: The Axis2Buttons boolean function for Logical or Virtual axis 9 freezes the device if the axis is moved towards the max value. The device must be restarted to recover. For this test I set up logical axis 9 to read from physical axis 1 on the SCE Gladiator: S...

You cannot assign and use the function for axes greater than 8. Boolean A2B allows referencing axes beyond 8: Screenshot 2025-10-15 093718.png This works fine if axis 11 is set to 8 bit. However if the axis is set to 9 bit, the A2B range is offset and maps to only one half of the axis: Screenshot 2...

Firmware: 2.17.6 - 2.19.E Software: 0.93.59 Issue: When multiple uSSW buttons are used to enable different POVs using the same axes, only the uSSW button for the highest POV# will disable the logical axes. POV1 and 2 read virtual axes 5 & 6: Screenshot 2025-09-03 233419.png When POV1 is enabled,...

Software: v0.93.46 The accepted range of manually-entered Bias values in the software is [-2047;2048]; Unfortunately this range is sometimes too small for some sensors. Fortunately bias values automatically set via ACn do not have this limitation, but sometimes manual calibration is necessary or mor...

This sounds like your deadzone is too small so the stick is never seen as centered, therefore the creeping value? Increase DzLo for the axis in question under profile > axes. Or is it that the value only increases no matter which side of the center you're moving? That's fixed in the latest experimen...

Yup it's fixed, thanks Alex.

Thanks, 2.19.D(2) fixes it.

I was testing the new MCounter options 2.19.6C when I came across this old friend, so bumping this to say it's still current.

Firmware: 2.19.A, 2.19.C.
Software: 0.93.46

Issue: When a logical axis is set to Relative mode with Linear curve, moving the physical lever in either direction makes the axis go up. The value can never decrease.

Awesome, thank you!

I don't like the new Calibration prompt in devcfg very much. That thing right here, opened by clicking 'Start Calibr.' in the tools tab: Screenshot 2025-06-29 120804.png Issue #1: It captures input. You cannot switch to other tabs after this thing shows up. Forgot to switch to the test tab? Too bad,...

Also if you push hard against the edges during calibration, that is where the maximum/minimum logical value for the axis will be set. Any time you want to reach this logical limit you will have to press equally hard against the edges. This is unnecessary stress on the material and unnecessary applic...

I'm testing on 0.93.36 (running fw 2.19.6) and can use two circular deadzones again.

Confirming that the issue persists with 0.93.34