VKB-SIM

Well, stupid me...! With the F-14 Combat Version grip, I was supplied a single tiny screw and a couple of washers that obviously "fit" on the base of the grip. Thinking this simple step had been inadvertently omitted from the videos I watched on assembly, I inserted the screw, tightened it...

I followed the steps you specified very carefully and had no problems with pitch and roll, the push and pull of the thumb wheel and the mini-throttle on the base. But twisting it left and right is very difficult still and I was only able to obtain partial deflection for the Rot Z slider. I was able ...

Thank you very much for your continuing assistance. You cleared up my confusion about the 4-way hat at the top of the joystick. On the test page for buttons, the default button is shown as button 13, and pressing the 4-way hat in 4 different directions causes buttons 9, 10, 11 & 12 to flash duri...

Tried using my Gladiator NXT EVO F-14 Combat Edition configured without the twist or 4 way hat working and Microsoft Flight Simulator did not display any mappings in the Controller Options. It was as though MSFS does not recognize that conntroller and provide any defaults for the controller actions ...

Still unable to "twist" the joystick and the 4-way hat barely causes any deflection when configuring.

Looks like I got the screen capture correct, anyway...

I followed your instructions, but I am still getting the same status error, the files are shown under the add files button, but the error message remains the same...? I tried shrinking the files on my iphone first before transmitting them to my PC but I am unable to extract them from the email and w...

I have dragged and dropped them to the message box but I am getting an error status that says: ERROR The image must be at least 0 pixels wide, 0 pixels high and at most 1800 pixels wide and 900 pixels high. The submitted image is 900 pixels wide and 1200 pixels high. So I don't understand what the i...

Here are 2 photos of the base with the plate removed...

After deleting VKBDevbCfg and installing it again, I somehow got the Find&AutoConfig to appear and pressed it. Had to repeat this action several times but eventually I got the test screen to appear and was able to Start Configuring. Then I ran into additional problems. The joystick worked easily...

NXT EVO joystick moves easily in both X-Axis and Y-Axis directions but is impossible to twist. Followed the instructions carefully for assembly, but unable to twist joystick at all. Is this an assembly issue or a defective part?

Tried to configure my F-14 NXT EVO by following the instructions in the online startup guide, but at the point where you press the Default button, you are supposed to be offered the option of selecting auto&config, but it doesn't appear...? Using Windows 11 Pro 64-bit and plan on using my NXT EV...