VKB-SIM

Ok, I seem to have been able to identify the component responsible for the comm error now. I started using the joystick for DCS Ah64 gunners position only and today I noticed the Windows chime for a device being connected while setting up my gaming setup. Checking VKBDevCfg-C I had connection to the...

Hello fallout9

I have opened #9087 on the Europe support page.

Kind regards

Hello Drano thx for the input. I have verified each of the 4 cables going into the white connector. Eeach cable seems to be correctly attached and is NOT loose. I can move each cable for 1/2mm and can also see the end of the cable moving inside the white connectors. They do look absolutely fine to m...

Hi

cables in white connectors are seemingly snug and fit well. Reconnecting and or jiggling the connectors does not change anything.
I tried switching cables 1 and 2 as well to see if this makes any difference (see pic below). I still have 100% comm error on the base.

I have tried additional troubleshooting steps now - connected Blackbox to different USB port - verified all cables for obvious loose connection - opened cable protector on conncetors between base and blackbox and verified for loose connections as well (visual inspection only) - Flashed device with Z...

Hello thank you for the feedback. Actually I did not press the Default button before I did the calibration yesterday. So I just wanted to try it again. Plugged the joystick back in the computer, started VKBDevCfg and unfortunately I am now back a square one. The GF base shows 100% communication erro...

This one?

Hello fallout9 here is the screenshot. Actually after todays reboot of my pc the sistuation changed and the communication error is gone BUT the axis still do not react. Situation after reboot vkb_issues_after_reboot.PNG Situation after reboot - Axes 1 window - Note: X/Y/Z axis are at maximum vkb_iss...

Hello I have a Gunfighter Mk.II with MCG Pro EN grip bought in 2018 - lot 1017\01. Unfortuanately the joysticks axis are completely dead while all buttons on the stick including axis still work. I have done the following - flashed the stick to current firmware version v2.11.5 and re-calibrated the s...