VKB-SIM

I have Z axis middle on the base of my EVO working on 2.14.A
Are you defaulting and calibrating after the firmware updates?

Bi Color LEDs should be firing as Color 1 green and Color 2 Red And should not be able to be set Red to Color 1 as far as I know. So there may have been something with how previous firmware was allowing Color 1 to be Red. Or reading that Red was the selection and firing the correct Side of the Bi Co...

@Pomax Just realized that 2.16 firmware and 0.92.87 VKBDevCFG showed up today on the downloads section of the vendor sites.
If you want to try it out.

Bummer. I just happened to be playing with firmware last night. I went up to 2.14.F and had zero issues with my dual SEMs. I can do a couple of things I couldn't do before now. I tried every firmware between 2.10.8 and 2.14.A. I just happened to give it another shot and push to 2.14.F and all my iss...

Excellent!
Glad that the Dual THQs are responding to 2.13.F better than my Dual SEMs.

No issue. Unless a game has a device limit. Sometimes you might need a VC to get around 32 button limit some games have also. Just shows up as another of the same device with the extra axes/buttons on it. If you change Global >> Common >> #But to 32 then any Logical Out value over 32 will be moved o...

I believe it is a USB C to JST similar to the GNX modules that go on an MFH.
USB C SBUS on the front of the STECS

No idea about the plates and being able to purchase them individually at some point or not.

Depending on the speed of the flash it sounds like the right stick is in calibration mode and needs to have End Calibr pushed in VKBDevCFG. However you will likely need to do another calibration either before End Claibr or starting a fresh one after End Calibr. That is partly my bad. There is a limi...

You can physically connect them together as a single unit, but you will need to use both USB cables from the EVO Bases. You can hook both the THQ and SEM to one EVO or hook the THQ to one EVO and the SEM to the other EVO. Some vids that might help https://youtu.be/hM6G_wvOCN4?si=hgu5-FyZ1uaG-9vI htt...

Should be an upgrade kit eventually, they are working towards making the GF IV accessories and T Rudder MKIV - MKV upgrade kits available.
Just a matter of time.
Wish I knew how long though to give a better idea of the wait.

BB3 LEDs once Defaulted and Calibrated properly should show.
SYS LED Blue
1 LED Green
2 LED Green
3 LED Off (I believe 3 LED is for a secondary S BUS Connection)

Downgrading firmware is the same as updating it. Worst case you have to short the boot jumper on the GNX HID Controller before plugging back into PC to get into boot mode for flashing. 2.13.F probably won't be seeing any more tweaks, it is just the last one Tuesday John has had luck with on GNX Modu...

It was also just pointed out to me at 0:48 in the vid in the text.

I missed that one when I was double checking earlier.

It is mentioned in the Voice Over.

It could have maybe used a little more info about the count in the text also.

From the video during programming the detents.
It appears as though you can have up to 3 detents setup and installed on a frame.
https://youtu.be/hwO5Q8L4x0E?t=252